10 Minute Seattle Water Heater Maintenance

Posted by on Feb 26, 2014 in Water Heater Repair Seattle

We are going to put you to work today, however only for about 10 minutes. Yep, that’s all it will take for these 2 vital water heater maintenance jobs; nevertheless, Water Heater Repair Seattleknows they will do an exceptional task of assisting with three things:

  1. Having your water heater last as long as possible (that will conserve you money).
  2. Ensuring the water heater runs safely (we do not want it to blow up).
  3. Having it run as energy efficiently as possible (also saving you cash).

So with that in mind, are you all set to invest ten minutes once or twice a year to assist in saving some money? Water Heater Repair Seattle WA thought so.

Testing the T&P Relief Valve

Typically called the T&P Valve, or the temperature and pressure relief valve, has an important task. It assists make sure excess pressure does not develop inside the water tank, or in even more easy terms, it sees to it the water heater does not blow up. As the photo reveals, it has a lever or little handle on it. All you need to do is lift it part method and then release it. Ideally, it snapped back to its shut position quickly. If it is working effectively, a little water can be heard going into the drain pipe below the lever you just raised and you maybe heard some pressure being released. If none of these things have actually occurred during the test, the valve will should be changed.

As inspectapedia.com states: “dripping TP relief valves are unsafe. The hazard is that minerals in the water supply accumulate inside the valve during the passage of hot water through the valve assembly. That accumlation of scale will eventually block operation of the relief valve, causing the relief valve to fail to operate properly if unsafe pressure or temperature occurs in the water heater in the future. The risk, ultimately, is a water heater tank or heating boiler explosion.”  (read more…)

Carry out a Mimi Water Heater Tank Flush

By nature, rust and deterioration will occur inside the water tank thanks to the chemical reactions taking place with all the parts inside that are required to warm the water. We will not get overly technical right here, however it is easy to assist avoid this process by doing a flush or draining of all or some of the water in the storage tank.

For just a tiny flush, put a bucket under the drain valve below the tank. Open the drain valve and fill the bucket with water. Drain at least a couple of gallons of water in total. Let the water sit in the bucket for a couple of minutes to settle and examine if there is much that settles to the bottom of the container. If there is, if the water heater has actually not been drained for a long period of time (or ever), it would be best to do a complete flush of the tank to get as much of the sediment out as possible. You will desire to turn the temperature dial down and might want to let the water cool off for about an hour first so it is not too hot while draining it. Also, it would be much easier to connect a hose to the drain valve and let the water go outside rather of making use of buckets.

If the water looks relatively clean and clear from the mini test you should be all set. When the water heater has an excessive quantity of sediment inside of it, it can make loud popping noises and it lowers its effectiveness too.

Though water heaters are relatively maintenance free and uncomplicated to operate, at any time you feel the slightest uncomfortable or are uncertain of what to do, it is always best to have a plumbing expert help with the circumstance.

Water Heater Repair Seattle