Signs of a Water Heater Failing

Posted by on Jan 4, 2016 in Gas Water Heater Repair Seattle, Water Heater Repair Seattle, Water Heater Use and Care

Water heaters normally do what they are supposed to accomplish and frequently go unnoticed up to the point when one needs a Seattle Water Heater Repair. Nevertheless, some of the problems that develop might be avoided by having frequent maintenance by a specialist. Make sure to pay attention to your natural gas burning hot water heater, because several of the problems that may appear might be expensive and dangerous for family members and animals. In this post, we’re explaining four indications that your gas water heater may possibly need to be replaced.

Dripping Water

In case there is water on the ground close to your hot water heater or dripping from a pipe, you could need to switch the hot water heater. However, depending on where the water is found and just how much there is, you may be just fine. In the event the water heater is leaking water from a pipe and there exists a little bit of water on the ground next to the water heater, it is more than likely the T&P valve. The temperature and pressure valve eliminates additional steam from the hot water heater, this kind of water vapor becomes to water and comes outside of the hot water heater by way of a pipe to the side of the tank. If perhaps this is the case, it happens to be totally typical and necessary for the heater to run accurately. Do not try to move the T&P valve and do not block it. In cases where you’re worried about the volume of water that is coming out of the pipe, call an expert! When the dripping water is originating from the base of the tank, it’s almost absolutely time to have a brand new hot water heater. When the hot water heater warms water the steel tank expands and contracts, and this movement may cause cracks and little fractures, which will eventually cause leaking. When this takes place, it is time to install a new unit.

CorrosionWater Heater Repair in Seattle

Around the pipes coming out of the hot water heater you will find pipe fittings which ought to be sealed well to be able to keep the pipe in place and keep water from seeping out of the hole. In case you’re seeing corrosion around these pipe fittings, water is leaking out of the hole. Though this isn’t a large leak and is not going to cause immediate harm to the water heater, in cases where the problem isn’t solved, severe and expensive complications will gradually develop.

Burn Markings

In the event that you are noticing burn marks around the bottom part of the hot water heater, there are 2 possible issues. But, both happen to be rather major and each of them call for a pro. One problem may be with the venting. If your venting is blocked or had been hooked up improperly, it could cause the exhaust fumes to go back in the home. This is unsafe and may lead to sickness or a fire when left unnoticed for long. However, it may not mean you will need to replace the hot water heater, and that is good. Another possible issue with burn marks can be the flue pipes inside of the water heater are clogged. This can result in a number of dangerous concerns and, unfortunately, the water heater will have to be updated as soon as possible.

Orange Flame Color

Gas burning water heaters have got a blue flame below the tank if it’s running. However, if you’re noticing that flame is an orange or yellow color, as opposed to blue, the burner is not operating accurately and is going to have to be checked by a professional.

There are several complications which can come up with gas burning hot water heaters, however by using consistent servicing and annual examinations, you should be able to prevent the need for an unexpected water heater repair in Seattle which might potentially be expensive. Contact us today if you observe anything uncommon with your hot water heater!